There happened some error, sir, I apologize for that error. Here is the result of ifconfig when I plugged in the adapter after starting the machine:
[email protected]:~# ifconfig
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 08:00:27:59:1b:51 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 16 bytes 960 (960.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 16 bytes 960 (960.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

wlan0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 00:c0:ca:96:64:e9 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 1 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

#after this I followed the same procedure as I described in another topic. Everything works fine, target pc is able to connect my fake AP, able to browse my localhost 192.168.1.1 index.php, but explicitly by typing 192.168.1.1 in the URL